New, Mega-Torque™ Electric Motor

Please see my Increase Generator Output by 10,000 Times page. That is my starting out point; in it, I discuss how to design/build an electrical generator that can generate 1000s or, even, tens of 1000s of more Watts of power from our generators.
OK. Most of us know that electrical motors are closely related to electrical generators. Most electrical motors use a rotating magnet within a coil structure made from copper wire. The motor turns based on attracting and repelling the magnet as it turns within the electrified coil.
Here is the new electrical motor; it uses a much more powerful magnet and, instead of a copper wire coil, one or more sleeves of my new coil alloy. Everything else is the same.
Alright, what is different? As the magnet is much more powerful, it can be attracted and repelled much more efficiently using much less power. Then, by using the coil alloy in sleeves around the armature, the digital charging of the attracting and repelling points can be enhanced by the additional “sleeves” of the coil alloy. The attraction and repelling of the armature (spinning magnet), can be aligned in a tight formation or can be spread out creating a different kind of push and pull.
It is important to visualize that the coil alloy sleeves can be divided into 360 degrees (or 3,600 Tenths of a Degree). Each of these digital points can be powered with either positive or negative energy to create a push or pull on the magnet. The coil alloy sleeve offers design options of one or many Push-Pull rings around the spinning magnet (armature). Think of a camshaft in a combustion engine.
The other thing that can be done is to electrify the coil alloy sleeves to make the push and pull more powerful.
This new Mega-Torque™ electric motor is a bit more complex, but will be much more powerful with much greater torque and can be operated at much lower electrical input power amounts.

3 Responses to New, Mega-Torque™ Electric Motor

  1. Kevin Bruce Kieran Larson says:

    Is this part of your design for the Electric Jet Engine?

    • Merln says:

      Yes. This will enable all, All, ALL electric motors to run with an order of magnitude (10x) or more increase in torque with less power to do so. So yes, this new electric motor will enable a large flow of air through various compression stages. Think of the compression blades as using my “Get Colder” alloy to make the air and water vapor more dense. So… the new thrust would be based on increased air flow (higher torque) and nearly freezing air/water output even in a tropical airport. Instead of carrying jet fuel, the aircraft will carry water to inject for more thrust. This takes the idea of after burning and flips it. No more pollution from burning jet fuel and the emissions are just water.

      This is important! This new electric jet engine is a major step in transitioning from Explosion to Implosion (to include compression, but without explosion) and is part of the energetic transformation we are all experiencing on our Planet.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.